Advice on double sided board

[odessa]

Thanks Brad

Spent a bit of time last night getting readings from my A/D inputs displayed and switches to change on screen setting etc just to test it all out.

My next code attempts are going to be controlling the graphics displayed and generally having fun with my new Dev board

I'll put up a little vid when I have made something impressive enought to post

Jay

[brad]

Look forward to it

[MrDEB]

I have a pretty good explanation on doing 2x boards (IMO)
http://digital-diy.com/General-Electron ... s-diy.html
Redoing a pic development board but no frills except a 4PDT switch for prg/tx,rx, a verasital 4 port LED port indicator, an LCD header and 3 push buttons..
All one sides with a few jumper wires.
Going to maybe look into the fre boards as suggested but for a different project.

[brad]

Do you have a higher res version of that schematic?

[MrDEB]

I can post the DipTrace files if that would help.
As can be seen, its a really BASIC board, no real frills.
I need to find out about FREE PCBoards as I have a Boy Scout merit badge electronics project that I am want to get some boards. Presently making my own but professionally made would be easier to sell.

[brad]

With the free boards, you only get a couple of them. But if you want more, they are only maybe $3 each.

Just get in touch with iteadstudio.com

[MrDEB]

here are the diptrace files for the developement board.
Very easy board with a 4PDT switch for TX/RX - PRGORAMING using the ICSP header.
4 pairs of LEDs for port pin status (HIGH or LOW)
Maybe help someone somehow?

[brad]

Thanks for uploading

[MrDEB]

Hopefully it will be of use to someone and maybe get some feed back on design etc.